Basic Mechanical Questions (IC Engines) Part – 6

February 20, 2016 | By | 1 Reply More

Welcome to the sixth part of sixth part of basic mechanical questions. These questions are useful for interview purpose and also for written exams. Hope you will be benefited from this. Lets begin –

  • What is the difference between turbocharger and supercharger ?

Ans : Turbocharger and Supercharger both have the same function. These devices are blowers which supplies extra air to the engine. As a result engine gets useful amount of oxygen to produce a proper ignition.

The main difference between the devices is that turbocharger uses exhaust heat from the exhaust gases as a power source. But Supercharger uses a part of the engine power to run. Turbocharger is not directly connected to the engine. It decreases the carbon emission because it has smog altering system. Supercharger on the other hand is connected to the engine with the help of a belt. It produces smog.

basic mechanical questions

  • What is the difference between the centrifugal pump and positive displacement pump ?

Ans : usually all the pumps are classified into this two categories. Actually in centrifugal pump flow rate varies with the change of pressure/pressure head. But in positive displacement pump the flow rate is always the same whether there is a pressure difference or not.

  • Differentiate between scavenging and supercharging / turbocharging ?

Ans: In Scavenging the burnt gases from the engine cylinder is pushed out by the fresh air that before the exhaust stroke ends. Turbocharging/Supercharging is the process of adding extra air to the engine for a better ignition.

  • Give the names of different Thermodynamic Processes .

Ans : Isothermal Process : Constant Temperature process

Isochoric Process : Constant Volume Process

Isobaric Process : Constant Pressure Process

Throttling Process : Constant Enthalpy Process

Isentropic or Adiabatic Process : Constant Entropy Process

  • Why more lubricating oil is needed in two-stroke engines than four stroke engines ?

Ans : In two stroke engine the lubricant is mixed with the fuel. As a result some of the lub oil is blown out with the process of scavenging and getting fresh charge. This phenomenon is not seen in four stroke engines.

  • What are Internal Combustion (IC) Engines ?

Ans : These are engines in which combustion of the fuel takes place inside the engine cylinder.

  • What are the usual sequence of operation in IC engines ?

Ans : The sequence involve : Suction Stroke, Compression stroke, Combustion, Expansion or Working Stoke and the exhaust .

  • What is the main difference between petrol engine and diesel engine ?

Ans: In petrol engine the ignition is initiated by the spark plug but in diesel engine the fuel and air mixture auto-ignites after reaching a certain temperature.

  • Describe different types of scavenging process or Define Crossflow Scavenging, Back flow or loop scavenging and Uniflow scavenging .

Ans :

Crossflow Scavenging: In Crossflow scavenging the inlet port and the outlet port is situated in the opposite sides in the engine cylinder. This type of scavenging is used in 2 stroke engines.

Back flow or loop Scavenging: In this type of scavenging the inlet and outlet port are on the same side.

Uniflow Scavenging: In this method the fresh charge can enter through one or two inlets . The exhaust port is situated on the top of the cylinder.

Please Read :

Category: Fluidics, Mechanical, Q & A, Thermodynamics

About the Author ()

Basic Mechanical Engineering is a small endeavor for the mechanical engineering students and fresh graduates. All the articles are written by mechanical "rocking" engineers \m/

Comments (1)

Trackback URL | Comments RSS Feed

  1. vipin says:

    hey, awesome questionnaire on four stroke engines… diagrams are illustrative this will help a lot to all mechanical engineering students.. thanks

Leave a Reply